Aerial view of a gray outdoor air conditioning condenser unit mounted on a concrete pad next to a house with vinyl siding.

HVAC Installation in Leesville, LA

A new system here will heat from November through March and cool from May through October every year. Tell us about the house, and a licensed contractor who covers Vernon Parish will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
Aerial view of a gray central air conditioning condenser unit on a concrete pad next to a house with vinyl siding.

Eleven months of the year, your system is working

In Vernon Parish, only one month goes by without the furnace or the air conditioner running. Summer afternoons average 92°F for six months, May through October. Winter nights average 40°F from November through March. A new system here needs to handle both, and handle them for most of the year.

Most homes in Louisiana heat with electricity, so a new system means thinking about what happens when the power goes out. Almost half of households in the state lost power for at least 24 hours in 2024, and this area has seen 39 damaging wind events over the past ten years. Whatever gets installed should be sized right for the heat and the cold, and it should be installed to hold up when the weather turns hard.

5 months
November through March, your system heats
6 months
May through October, it cools
40°F
the average winter night it heats against
92°F
the average summer afternoon it cools against
Isometric line illustration of a cutaway house showing interior rooms, ceiling ductwork connected to an indoor air handler, and an outdoor condenser unit linked by refrigerant lines.
Your system heats November through March and cools May through October.

NOAA nClimDiv, 1991–2020 normals

Louisiana requires HVAC contractors to hold a state license.

The Louisiana State Licensing Board for Contractors is the one that tests and licenses HVAC contractors here, and the license belongs to the contractor, not to any single job. That means the same license covers this installation as would cover the next one, and the board has a record of who holds it.

For a system install, the license is not the only check. In most cities and parishes, putting in a new furnace or air conditioner needs a permit from the local building office, and the work gets inspected once it is done. That inspection is what catches a bad gas connection or a duct run that was not sealed right, separate from anything the state license covers.

Source: Louisiana State Licensing Board for Contractors

When should I replace my HVAC system?
Once repairs start happening every year, or the unit is old enough that parts are getting hard to find, replacement usually makes more sense than another repair. A furnace or air conditioner that keeps breaking down in the same season it just failed in is telling you something. With 5 months of heat needed here and 6 months of cooling, a system that struggles through one of those stretches is going to struggle again the next time around. A contractor can look at the age and condition of your specific system and tell you whether it is worth fixing again.
Should I replace my furnace and air conditioner at the same time?
If they are close in age, replacing them together often makes sense, since a furnace and air conditioner installed years apart wear out at different times and one failing tends to mean the other is not far behind. They also share parts of the same system in many homes, like the air handler or ductwork, so replacing one can affect how the other performs. That said, if one unit is much newer than the other, there is no reason to replace something that still has years left in it. A contractor can look at both and tell you what makes sense for your house.
What happens during an HVAC installation?
A contractor removes the old furnace and air conditioner or heat pump, then sets the new equipment in place and connects it to the ductwork, refrigerant lines, gas or electric supply, and thermostat. Louisiana requires HVAC contractors to hold a state license for this work, and in most cities and counties the job also needs a permit from the local building office along with an inspection once it is finished. After everything is connected, the contractor tests the system to make sure it heats and cools the way it should before calling the job done.