HVAC Installation in Crowley, LA
A new system here will heat from November through March and cool from April through October every year. Tell us about the house, and a licensed contractor who covers Acadia Parish will get in touch.
Tell us about the job
It takes about a minute.
Twelve months of work, split almost evenly
In Crowley, a new system doesn't get an off season. Cooling runs April through October, seven months, against summer afternoons that average 91°F. Heat takes over November through March, five months, on winter nights that average 44°F. That's the full year, split between two jobs.
Most homes here heat with electricity, so the system has to earn its keep both ways. And storms are part of the picture too. Acadia Parish has seen 48 damaging wind events over the past ten years, and close to half of Louisiana households lost power for at least a day in 2024. A new install should be sized right for both seasons and set up to start back on its own once the power does.
- 5 months
- November through March, your system heats
- 7 months
- April through October, it cools
- 44°F
- the average winter night it heats against
- 91°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Louisiana requires HVAC contractors to hold a state license.
The state license comes from the Louisiana State Licensing Board for Contractors, and it covers the contractor, not the individual job. That means the board has tested this contractor and keeps a record of them, but passing that test once does not follow them onto your property for this particular installation.
What follows them onto your property is the permit. In most cities and counties here, putting in a new furnace or air conditioner needs a permit from the local building office, and the work gets inspected once it is done. That inspection is what checks the gas connections, the wiring and the refrigerant lines on this specific job, separate from whatever the state already knows about the contractor's license.
Source: Louisiana State Licensing Board for Contractors
- When should I replace my HVAC system?
- Replace it when repairs keep coming back, or when the system can no longer keep up on the coldest nights or hottest afternoons. Summer afternoons here average 91°F and winter lows average 44°F, so a furnace or air conditioner that struggles on an ordinary day will fail on one of those. An aging system also tends to cost more to run before it fails outright, since it works harder to hold the temperature. A contractor can check whether yours is worth repairing again or worth replacing.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, it usually makes sense to replace them together. A furnace and air conditioner often share a coil and a blower, and pairing a new unit with an old one means the new one is limited by the old one's parts. Homes here need heat five months a year and cooling seven, so both sides of the system see real work all year. A contractor can tell you whether your current pair is still matched or worth splitting apart.
- What happens during an HVAC installation?
- A contractor removes the old equipment, sets the new furnace or air handler and outdoor unit, and connects the ductwork, refrigerant lines, gas line or electrical circuit the system needs. They check that the ducts are sized right for the new equipment, not just reconnected as they were. Once it's running, they test it through a full cycle and check refrigerant charge, airflow and temperature rise. In most cities and counties this work needs a permit and an inspection when it's done, so ask that it's pulled before work starts.